SCOTT HEALTH & SAFETY VISION 2 Instrucciones De Funcionamiento página 10

VISION 2
To Replace the Inner Mask:
1. Remove screws from the front
cover and remove front fitting from inside
of mask.
2. Gently pull the inner mask from
front fitting and feed the rim of the new
inner mask into the groove in the front
fitting.
3. Re-position front fitting inside the
mask and align with front cover.
4. Secure front cover to front fitting by
tightening the two
evenly.
retaining screws
STORAGE
When not in use, the equipment should
be stored in a clean, dry environment,
away from direct heat sources between
+10ºC and +30ºC, at a humidity of less
than 65% RH.
NOTIFIED BODIES
Inspec International Ltd
(Number 0194)
Upper Wingbury Courtyard,
Wingrave,
Aylesbury,
Buckinghamshire,
HP22 4LW,
United Kingdom.
British Standards Institute
(Number 0086)
389 Chiswick High Road,
London,
W4 4AL,
United Kingdom.
8