CHARGING THE BATTERY
1. Make sure the appliance is switched off.
2. Insert the charger into the mains socket and
connect the cord to the charger socket on the
hand-held vacuum cleaner.
3. Switch on the power. The red recharging
indicator on the appliance lights up.
HANDLOE FOLDING FOR STORAGE
Firmly press the handle release button located half way down the handle shaft, to enable
the handle to rotate freely in the vertical plane, and rotate the handle to the folded state. If
you want to use the cleaner, rotate the handle to the vertically upward position to make
the handle fi xed through automatic locking.
DOST CONTAINER AND FILTER
This appliance is not equipped with a dust bag. The dust/dirt is sucked up into the transparent dust
holder instead. Once the dust is in this container, it whirls around so that it does not block suction. The
air sucked in is cleaned by means of a two-component washable permanent filter in the dust container.
EMPTYING THE DUST CONTAINER AND CLEANING THE FILTER
IMPORTANT: if the appliance loses suction power during use, the filter pad may be dirty, and needs
cleaning or replacing. Never use the appliance, when the filter is dirty or when it has not been replaced.
1.
Detach
cleaner from the appliance by
pressing the release button whilst
simultaneously
hand-held vacuum upwards.
the
hand-held
vacuum
pulling
4. Leave the battery to fully charge - approx. 20
hours. If the battery is completely discharged,
the recharging indicator remains lit while the
appliance is connected to the charger.
5. Switch off the power and remove the charger
from the mains socket after recharging is
completed.
2. Grab the dust container with one
hand and press the opening button
to release the dust container from
the
the motor section.
-20-