Jocel JCV-8002D Manual De Instrucciones página 22

3. Pull the two parts of the filter out of the dust
container and empty the container. If necessary
rinse the dust container with clean water and
wipe the container with a dry cloth.
5. Place the top part of the filter on the bottom part,
and place the filter in the dust container. Press
down the filter far enough so that it fits tightly to
the sides of the dust container. The filter can
only be fitted in one position.
6. Mount the dust container by pressing it fi rmly
onto the motor selection. Check that the lock tab
CLEANING
•
Clean the appliance by wiping it with a damp cloth. A little detergent can be added if the appliance is
heavily soiled.
•
Never use a scouring pad, steel wool or any form of strong solvents or abrasive cleaning agents to
clean the appliance, as those may damage the outside surfaces of the appliance.
•
Clean the filter as described above. When the filter pads are worn or cannot be properly cleaned,
replace them with pads of the same type.
•
Check that the dust container and the filter are completely dry before the appliance is assembled and
used again.
4. The filter consists of two sections, both of
which must be cleaned. Brush the parts with a
small brush and/or wash them in tepid water.
Add a little detergent if necessary. Check the
filter pad is completely dry before replacing into
the appliance. NEVER insert a wet filter into the
appliance.
on the motor section clicks into place in the hole
on the dust container so that the dust container
is firmly mounted on the motor section.
7. Replace the hand-held vacuum cleaner on the
appliance
-21-