Troubleshooting - Fulbat Fulload 1500 Manual De Instrucciones

constant at the set value.
• Analysis Mode (Battery retention test Mode)
- The charging is interrupted for a short period for battery voltage
measured.
- If the battery voltage falls too quickly, the battery is probably faulty.
- The Yellow Charging LED is ON (if above situation occurred)
• Float Mode (Safe voltage level of 13.6V)
- Full Green LED is ON.
- The Float Mode allows the charger to effectively be left connected
to your batteries; it works at a safe level of 13.6V, and ready for use.
• Maintenance mode (Special pulse for long term maintenance)
- Full Charge Green LED is ON.
- The program engages a special charging waveform and monitors
the battery voltage variety, if the battery voltage sinks, the special
pulses will keep the battery in optimal state, if the battery voltage
drops even lower, the battery charger will switch into Bulk charging
stage.
- The maintenance mode allows the charger can be connected to
the battery over the course of a season; if possible; check the
electrolyte liquid level in the battery.
LED STATUS INIDICATOR TABLE
LED
Power / Fault LED - Green / Red
Charge / Reconditioning
LED - Blue / Yellow
Full Charge LED - Green
FULBAT - www.fulbat.com
Status Descriptions
Green On AC power is connected
ECO mode and no battery
Green Flash
presented
Short –circuit or Reverse
Red On
polarity
Bulk charge (C.C) mode /
Blue On Absorption charge (C.V)
mode
Blue Flash Recondition / Soft start
Yellow On Battery failure
The charger is at Float mode
Green On
(Full)
Recovers sulphated Increases battery life
batteries with a high by gently starting to
frequency pulse. charge the battery.
CHARGING CURVE (VOLTAGE)
CHARGING FEATURES
FULLOAD 1500 - 8 STAGES
Voltage
(V)
Current
(A)
INITIAL REJUVENATION SOFT START
QUALIFICATION
Rejuvenates Increases
Test automatically sulphated battery life by
battery condition batteries with a gently starting to
and determine if high frequency charge the
charger engages pulse. battery.
rejuvenation
or charging cycle.
CHARGING FEATURES
TROUBLE SHOOTING
Voltage
(V)
Current
(A)
Types of
INITIAL REJUVENATION SOFT START
Indication
QUALIFICATION
Problems
Rejuvenates Increases
Test automatically sulphated battery life by
battery condition batteries with a gently starting to
and determine if high frequency charge the
Charger
charger engages pulse. battery.
No Indicator
rejuvenation
or charging cycle.
does not
lights ON
work?
Charger
Fault LED
has no DC
is ON
output?
No Charging Fault LED
Current? is ON
Long char-
ging time,
Fault LED
Full light
is ON
does not
come on?
MAINTENANCE
The charger is maintenance free. If the power cord is damaged, the
charger must be left to the reseller for maintenance. The case should
be cleaned occasionally. The charger should be disconnected from the
power while cleaning.
5
Reduces charging time Ensures a full charge
by delivering maximum to the battery without
charge to set voltage. overcharging.
BULK CHARGE ABSORPTION BATTERY TEST FLOAT
Reduces charging Ensures a full Tests the battery Float charge
time by delivering charge to the to ensure fully maintains the
maximum charge battery without charged. battery at
to set voltage. overcharging. 100% charge.
21 days restart.
FULLOAD F12 - 9 STAGES
Possible
BULK CHARGE ABSORPTION EQUALIZATION BATTERY TEST
Suggested Solution
Causes
Reduces charging Ensures a full Returns a full Tests the battery
time by delivering charge to the hydrometer to ensure fully
maximum charge battery without reading to charged.
to set voltage. overcharging. - calcium batteries
Check AC connections and
by removing acid
stratification.
-
No AC power make sure Power Point is
switched ON
-
Check DC connection between
-
Output charger and battery and
is short make sure they are not short
circuited circuiting
- -
Reverse Check that the crocodile clips
polarity haven't fallen off the battery
-
connection Check that the crocodile clips
to Battery / ring terminals are connec-
ted to the correct polarity
-
Battery is
severely
-
Check the Battery condition,
sulphated
age etc
-
Battery has
-
Battery may need
a damaged
replacement
cell
-
Move battery & Charger to
-
Overheat
cooler environment
protection
mode
- -
Battery Check the charger specifi-
capacity too cation matches the battery
large capacity
- -
Battery is Battery cannot be charged
defective and must be replaced
Float charge maintains
the battery at
100% charge.
LONG TERM
MAINTENANCE
If the battery
voltage sinks, the
special pulses
will keep the
battery in
optimal states.
FLOAT LONG TERM
MAINTENAN
Float charge
maintains the If the batter
battery at voltage sinks,
100% charge. special puls
21 days restart. will keep th
battery in
optimal state