Technical Data - Fulbat FULLOAD F4 Manual De Instrucciones

TECHNICAL DATA

Input voltage:
Rated voltage outgoing:
Ambient Temperature:
Charging battery types:
SAFETY
Children or persons who lack the knowledge or experience to use the device or whose physical, sensory or intellectual
capacities are limited must never be allowed to use the device without supervision or instruction by a person
responsible for their safety. Children should be supervised in order to ensure that they do not play with the appliance.
WARNING Never use the charger for charging of non-rechargeable batteries. During charging, place the removed
battery on a well-aired surface. The automatic operating mode and the restrictions in use are explained further below
in these instructions.
DANGER OF ELECTRIC SHOCK!
Do not operate the appliance if the cables, the mains cable or mains plug are damaged. A damaged mains cable
indicates a life-threatening danger due to electric shock.
Before connecting to the power, ensure that the power connection is earthed, is 120V 50Hz, and is 16A fused and
equipped with an RCCB switch (residual current circuit breaker) in accordance with the current regulations. Disconnect
the charger from the grid, before you make or break connections to the battery.
First, connect the clamp that is not connected to the bodywork. Then connect the other clamp to the bodywork, away
from battery and fuel pipe. Only after this, connect the charger to the grid.
After charging, disconnect the charger from the grid. Only after this remove the clamp from the bodywork. Following
this, remove the clamp from the battery.
DANGER OF EXPLOSION AND FIRE HAZARD!
Protect yourself from a highly explosive hydrogen-oxygen reaction.
Ensure that during charge and charge retention procedures, there are no flames or sparks Ensure that the plus cable
does not come into contact with fuel lines (e.g. petrol pipe or grounded metal).
Ensure the charger and contacts are away from handle material
DANGER OF CHEMICAL BURNS!
Wear protective glasses! Wear protective gloves. If eyes or skin has come into contact with battery acid, rinse the
affected body region off with a large amount of clean water and soap.
Avoid causing a short circuit when connecting the charger to the battery. Connect the negative pole connector cable
only to the negative battery or to the body work. Connect the positive pole connector cable only to the plus pole of the
battery.
Do not place the charger close to fire, heat or to places with long-term exposure to temperatures over 50°C.
Ensure that no fuel lines, electric cables, hydraulic or water pipes are damaged by the screws during assembly of the
charger.
Do not cover the charger with any objects. Protect the electrical contact surfaces of the battery from short circuiting.
Only use the charger for charging and for float charging retention of 6V/12V lead batteries. Do not charge frozen
batteries.
OPERATION
Before use
Before connecting the charger, the operating instructions must be observed. Furthermore, the instructions of the
vehicle manufacturer regarding a permanently connected car battery must be observed. Secure the car, switch off the
ignition. Clean the battery poles. Take care that while doing so, your eyes do not come into contact with the dirt.
Ensure sufficient ventilation.
Connecting
Connect the "+" pole clamp (red) 14 of the charger to the "+" pole of the battery.
Connect the "-" pole clamp (black) 15 to the "-" pole of the battery.
Connect the mains cable 13 of the charger to the mains socket.
The battery voltage display 9 shows the current battery voltage.
110V or 230V AC
6V/12V DC
0*C to 40*C
6V lead acid battery
12V Lead acid battery
Rated power: 60W
Rated output current: 0.8A/3.8A
Housing Protection type: IP 65
1.2Ah-14Ah
1.2Ah-120Ah
3