Battipav Super Pro 450 Manual De Instrucciones página 11

d) Place the rod onto which the tile rests on the
front part of the worktop, by inserting the screws
into the respective holes found on the worktop
itself (picture 3).
e) Verify that the cutting tool is set at the 0 cm
position of the rod onto which the tile rests.
4
f) Adjust the rod onto which the tile rests for it to
be perpendicular to the cutting side.
g) Then tighten the nuts with the 10 mm hexagonal
spanner (picture 3).
h) Insert the rod support fence into the relative
housing.
i) Remove the M6 nut from the blocking lever with
the 10 mm hexagonal spanner.
l) Insert the lever into the opening near the rod
support fence housing.
m) Bring the blocking lever to rest on the rod
support fence, as shown in picture 5.
5
n) Block the lever blocking unit of the rod into
place with the spanners supplied.
CAUTION !
THE ROD SUPPORT FENCE IS BLOCKED INTO
PLACE BY TURNING THE LEVER ANTI-
CLOCKWISE.
LEFT-HANDED OPERATORS
a) Set up the carriage rod unit onto the worktop, as
shown in picture 6
b) Centre the cutting wheel of the carriage as
shown in point "a" in the paragraph dedicated to
right-handed operators (picture 2)
c) Block the carriage rod unit into place with the
four screws supplied.
6
d) Unscrew the knob that blocks the fence in
place.
e) Turn the fence upside down and retighten the
knob back into place.
7
THE BLOCKING KNOB MUST BE ALIGNED
WITH THE CENTRE OF THE CUTTING SIDE OF
THE WORKTOP BEFORE TIGHTENING IT, IN
ORDER TO OBTAIN A CORRECT 90° POSITION
OF THE FENCE.
11
GB