Troubleshooting - Battipav Super Pro 450 Manual De Instrucciones

Cortadora de azulejos profesional
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
EXCESSIVE ADJUSTMENT OF THE SCREWS
WILL PREVENT THE CUTTING CARRIAGE
SLIDING PROPERLY.
e) When required, lubricate the vertical sliding
seating on the H-shaped support for the foot
(photo 13).
13

7. Troubleshooting

THIS TOOL MUST ONLY BE REPAIRED BY TRAINED PERSONNEL.
Repairs must only be carried out by trained personnel, using original spare parts. Any other repairs
may put the user at considerable risk.
Problem
The cutting carriage is difficult to
slide.
The
cutting
carriage
unevenly.
The cutting wheel does not cut
correctly.
Cause
The carriage rod is encrusted
with cutting residue.
The carriage rod is worn.
The bearings on the cutting
carriage are worn.
There is too much play on the tile
cutter.
slides
The bearings on the cutting
carriage have been damaged.
The clamp on the cutting foot
support is worn.
The cutting wheel is worn.
The screw on the cutting wheel
support has become loose.
6. Disposal
When the entire machine or part there of is
disposed of, the materials are to be disposed of in
accordance with current legislation.
Steel
Carriage rod
Steel
Aluminium
Steel
Solution
Clean cutting residue off the rod
and check that the carriage is
adjusted correctly.
Contact your local dealer to
replace the carriage rod.
Contact your local dealer to
replace the bearings.
Check that the carriage is
adjusted correctly.
Contact your local dealer to
replace the bearings.
Contact your local dealer to
replace the cutting foot.
Replace the cutting wheel.
Check that the cutting wheel is
adjusted correctly.
13
Worktable
Carriage
GB
AC
AC
AL
AC

Publicidad

Tabla de contenido
loading

Tabla de contenido