Care And Maintenance - KIKKA BOO FOLIAGE Instrucciones De Uso

WARNINGS
• The reclined cradle is intended for the maximum weight of child with 9 kgs.
• Never leave your child unattended in the rocker!
• It is dangerous to use the reclined cradle on an elevated surface: e.g.: a table.
• Always use the safety harness.
• Assemble and adjust the rocker with care. Before using, check the condition of the two regulating mechanism adjust the
position of the backrest (Figure 5).
• On adjusting the position of the backrest you must be sure that both mechanism are well locked in the chosen position.
• Don't leave the rocker near a switched-on fan, Heat sources, sharp objects and water containers.
• Do not use the reclined cradle once your child can sit unaided.
• This reclined cradle is not intended for prolonged periods of sleeping.
• This reclined cradle does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a suitable
cot or bed.
• Do not use the reclined cradle if any components are broken or missing.
• Do not use accessories or replacement parts other than those approve by supplier.
• Never use the toys bar to carry the reclined cradle.
ASSEMBLING
1. Interlock the two base frame tubes as shown on (Figure 1) by pressing the small buttons (Figure 2).
2. Assemble the another side as the procedure one.
3. Fasten the textile belts as backside of the rocker (Figure 3).
4. Interlock the backside base frame to the two button base frame (Figure 4).
5. The bouncer is ready to use. By simultaneously pressing the buttons (Figure 5) of the adjusting mechanism of the
backrest, put it in the chosen position.
MARK: here are ve positions of backrest. When the four plastic feet in the bottom is folded, the bouncer is ready for
swinging. Stop the swinging by putting the four plastic feet at the far end of the main tube.
6. To install the toy bar and press the attaching clips to the metal body pipes until "click" sound is heard (Figure 6).
DISASSEMBLING
1. Disassemble the backside base frame from the bottom base frame (Figure 7).
2. Disassemble the two bottom base frame from the main rocker body by pressing the small button (Figure 8).

CARE AND MAINTENANCE

• The cover of the rocker can be washed in washing machine and temperature shouldn't be higher than 40 degree.
• The metal and plastic parts can be cleaned with lukewarm water and mild soap detergent.
ENGLISH