babymoov A014200 Instrucciones De Uso página 16

2. Switch the start/stop switch (11) to ON and wait until a
the screen.
3. Maintenez enfoncé le bouton (3) sur l'émetteur.
4. Switch the start/stop switch (1) to ON and wait until the
the Baby unit number starts flashing on the screen (if need be repeat the
operation with the additional Baby unit).
5. Use buttons (2) (3) ▲▼ to select the number of the transmitter (1) or (2). Do NOT
define the same number for each transmitter; this stops the system from
working properly.
6. Press the "Menu" button (4) to confirm your selection; the number of the
transmitter is now steady and the
7. Now press the "Menu" button (4) of either transmitter; if the connection has
worked the receiver makes two beeps. The
and the number corresponding to the transmitter must appear in the top right
corner of the receiver's screen.
8. Press the "Menu" button (4) of the 2nd transmitter; the receiver has to make
two beeps. The is steady on the transmitter's screen and flashes twice on
the receiver's. The number corresponding to the transmitter appears in the top
right corner of the receiver's screen.
9. Switch off all the appliances and then switch them back on. The babyphone is now operational.
10. If the receiver and the transmitter do not succeed in communicating start the connection procedure all over again.
N.B. If you had only one transmitter to start with and you subsequently bought an additional transmitter, carry out
the above procedure once again to connect the 3 appliances.
A/ TRANSMITTER
1. Configuration of the "Out of range" alert function
a. Switch the start/stop switch (1) to ON to switch on the LCD screen. Keep the "Menu" button (4) down for at
least 5 seconds to have access to the programming mode. This is what is displayed on the screen:
or
b. Use the (2) (3) ▲▼ to configure the "Out of range" alert function. "On" means the function is activated and "Off"
that it is inactivated. If you select "Off" it allows the transmitter's emission level to be reduced. However, the receiver
no longer emits any alarm if the transmitter is out of range and the temperature of the room in which the
transmitter is located as well as its charge no longer appear on the receiver's
screen when it is in stand-by mode.
c. Confirm the selection by pressing the "Menu" button (4), the screen returns
to normal mode. If you have selected "On" the "Out of range" alert icon
appears on the screen.
d. In stand-by mode, briefly press the "Menu" button (4) to display the
configuration of the "Out of range" alert.
16
starts to flash.
has to be steady on both screens
FUNCTIONING
■ STEADY
■ FLASHING
BABYPHONE DIGITAL GREEN • Instruction Manual
starts flashing on
becomes steady and
■ STEADY
■ FLASHING