Attaching The Viewfinder To A Camera/Camcorder; Attaching The Viewfinder - Sony DXF-801 Manual De Instrucciones

• The lower indicator can be enabled by the
menu settings of the camera/camcorder.
For details, see the operating instructions for the
camera/camcorder.
g GAIN UP indicator (orange)
This lights when the gain of the camera/
camcorder is 3 dB or more.
h SHUTTER indicator (red)
This lights when the SHUTTER switch of
the camera/camcorder is set to ON.
i PEAKING control
This adjusts the outline intensity of the
viewfinder image. (See page 20.)
j CONTRAST control
This adjusts the contrast of the viewfinder
image. (See page 19.)
k Tally lamp
When the TALLY switch qf is set to ON,
this operates in the same way as the REC/
TALLY indicators 6.
l BRIGHT (brightness) control
This adjusts the brightness of the
viewfinder image. (See page 19.)
m Eyepiece release catch
To view the viewfinder screen directly,
press this catch, and hinge up the eyepiece.
n TALLY switch
Set this switch to ON to use the tally lamp
qa.
o DISPLAY switch
Set this switch to OFF when you want to
hide the character data from the viewfinder
and the monitor of the camera/camcorder
connected to the MONITOR OUT
connector.
p Viewfinder connector (20-pin)
Connect this to the VF connector of the
camera/camcorder.
Attaching the
Viewfinder to a
Camera/
Camcorder
Notes
• When the viewfinder is attached, do not
leave the camera (or the camcorder) with
the eyepiece facing the sun. Direct
sunlight can enter through the eyepiece,
be focused in the viewfinder and cause
fire.
• Be sure to power off the camera/
camcorder before plugging the
viewfinder connector into the VF
connector on the camera/camcorder. If
the connector is plugged in while the
power is on, the viewfinder may not
operate correctly.
• Make sure that the viewfinder connector
is pushed fully into the VF connector on
the camera/camcorder. If the connector is
not firmly connected, the image may
break up, or the tally lamp may not
operate properly.
• The DXF-801 cannot be directly attached
to the viewfinder shoe of the PDW-F350.
Replace the shoe to attach the DXF-801
to the PDW-F350. For details, please
contact your Sony dealer or a Sony
service representative.

Attaching the Viewfinder

First disconnect the microphone from the
viewfinder.
1
Slide the viewfinder onto the
projection on the camera/camcorder,

Attaching the Viewfinder to a Camera/Camcorder

17