connector located on the front of the compressor.
8. Attach mouth piece or mask per your choice to the
top section of nebulizer.
9. Plug the power cord into an appropriate electrical
outlet. Make sure at this stage, the power switch is at
"O" status.
10.Press power switch to begin your prescribed
treatment.
Important:
The compressor motor has a thermal protector which
will shut off the unit before the unit is overheated.
When the thermal protector shuts the unit off, please:
a. Switch off the unit.
b. Unplug the unit from the electrical outlet.
c. Wait 30 minutes for the motor to cool down before
another treatment. Make sure the air openings are
not obstructed.
When treatment is finished, shut off the unit and unplug
it from the electrical outlet.
5. CLEANING
It is recommended that the nebulizer, mouth piece and
mask are thoroughly cleaned with hot water after each
use and cleaned with a mild detergent after the last
treatment of the day. If your physician or respiratory
therapist specifies a different cleaning procedure, follow
their instructions.
Rinsing (after each treatment)
1. Disconnect the air tube, nebulizer, mouth piece
and mask.
2. Gently twist the nebulizer to open it.
3. Rinse the nebulizer, mouth piece and mask with water.
4. Dry them with clean soft towel or let it air dry.
5. Reassemble the nebulizer when completely dry and
put these parts in a dry sealed container.
4