MRA Z250 2013 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA-Screen
2 Allen screws M5 x 25
2 Allen screws M5 x 20
4 O-Rings 4,5 x 1,5
4 Plastic washers 12 x 5mm
2 Distance sleeves 10mm
2 Distance sleeves 6mm
1 Edge trim with clamp sleeves
Fitting the screen to the motorcycle:
1. Stand your motorbike up on a level surface.
2. Dismantle the original screen (P1).
3. Insert the M5 x 20 Allen screws with the plastic washers through the lower holes of
your MRA screen, then place the 6 mm spacers onto the screws from the inside and
secure them using the O-rings (P2).
4. Insert the M5 x 25 Allen screws with the plastic washers through the upper holes of
your MRA screen, then place the 10 mm spacers onto the screws from the inside and
secure them using the O-rings (P2).
5. Position the MRA screen and tighten the screws (P3).
6. Mount the edge protection strip onto the screen as shown in P4. Slide the clamping
sleeve over the ends of the edge protection profile and press it with a pliers together
slightly, so that the edge protection profile is clamped.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Kawasaki Z250 13-/Z300 15-
Article No..
--- Allen key 3 & 4mm
10641
10673
10992
10635
10633
11038
---
3
Required tools