Luisi Air Brava SLT105 Instrucciones De Uso Y Montaje página 12

USES
The appliance can be arranged only for filtering
performances.
In its filtering version the air and fumes conve-
yed by the appliance are cleaned both by a grea-
se filter and by an active coal filter, and put again
into circulation.
INSTALLATION
At tge beginning make sure that the package is
intact and all the parts are unbroken, otherwise
stop the installation and contact the dealer.
The manufacturer is not responsible for da-
mages caused by material handling or pro-
duct installation.
Before installing the appliance read all these
instructions carefully.
Take the wall bracket from the packaging and in-
stall it, by means of using the provided screws
and small blocks, as in figure 1. It is possible to
use the same bracket as a template and draw the
drilling to be done in the wall.
Warning: before fixing the bracket it is necessary
to pay attention to the following:
1 -The feeding cable must be inside the bracket,
as shown in fig. 2; 2 - The bracket must be instal-
led with a perfect horizontal axis in regard to the
floor, as in fig. 3; 3 - The wall on which the product
is installed must be robust enough, considering
that the product as a weight of approximately ....
kilos.
Take the ducting product from the packaging.
Protect the installation pipe with some paper sel-
lotape, as shown in fig. 4.
Insert the wall plate, as shown in figure 5, paying
attention not to damage the finishing of the pipe -
protected with the paper sellotape, as described
in the previous point.
Fix the product to the wall bracket, previously in-
stalled, inserting the installation pipe in the speci-
fic socket of the bracket, see fig. 6.
Clamp the product, using the provided screw, in-
serting it as in fig. 7. Fix it all, using the provided
M6 nut.
In case the product proves to be not perfectly per-
pendicular to the floor plan, it is possible to do a
further adjustment, securing the screw indicated
in fig. 8, to move the lower part of the product
away from the wall on which it is installed (fig. 9).
While securing the screw (fig. 8), push the lower
part of the product from the bottom up to ease the
adjustment.
Proceed with the electrical connection of the pro-
duct (fig. 16).
Place the cover on the wall plate (fig. 10), then fix
it with the two provided screws (fig. 11).
12