Steren STV-065 Manual De Instrucciones página 2

32" TO 65" CEILING MOUNT
NECESSARY TOOLS FOR INSTALLATION
Steren is not responsible for material or personal damages caused by misuse or improper installation. It is the
responsibility of the user to ensure the correct installation and use of the product, as well as its periodic review.
Complements the telescopic bar, with the second segment and the screen support at the
5
desired height. Fix both parts using the screws (F), the washers (H) and the nuts (K).
IMPORTANT
STV-065
Before using the product, read this manual carefully to avoid any malfunction.
The information presented serves only as a reference on the product; Due to updates there
may be differences.
Check our website www.steren.com for the latest version of this manual.
CAUTIONS
Instruction manual
• This device is not intended for use by persons (including children) whose physical, sensory
or mental abilities are different or reduced, or who lack experience or knowledge.
• Children should be supervised to ensure they do not use the device as a toy.
• This product is designed for indoor use.
• The support must be installed on a solid surface.
• The maximum load capacity (40 kg) must not be exceeded.
0119m V1.0
INSTALLATION
1 Use the ceiling stand as a template to make
the perforation marks in the place where
you want to install it. Select 2 holes on each
side.
Use 4 screws (A or B), the 4 hub spacers (J) and the 4 washers (G) to fix the bars on the
6
back of the screen. If you require wider screws, only use the screws (C) and the hub spacers
(J), without the washers.
Do not install screens over 65 "or weighing more than 40 Kg
Observe that the bubble is in the center,
The screws supplied are standard sizes. We recommend you consult the instruction manual of your screen to obtain
to verify that the support is level
information about the screws necessary to mount it in a support.
CONTENT
PIECES
Holding bars
pieces
(2 )
SCREWS
M4x20 mm
A (4 pieces)
WASHERS, HUBS, NUTS AND ANCHORS
M6
G (4 pieces)
Perform the holes to a depth of 60 mm, with
2
a drill of 10 mm in diameter.
Assemble the ceiling stand and the first segment of the
3
telescopic bar, as shown in the figure.
Loosen the fixing screws, and mount the screen on the support by first placing the upper
7
part of the bars (in hook form) and then the lower part.
Tighten the screws
to fix the screen
Make sure that the bars
are perfectly coupled
TV stand Ceiling stand Telescopic bar
(1 piece) (2 segments) (2 segments)
M6x20 mm M8x25 mm M6x8 mm M8
B (4 pieces) C (4 pieces) D (2 pieces) E (4 pieces)
M6 M8 M8 M6
H (4 pieces) I (4 pieces) J (4 pieces) K (4 pieces)
60 mm
Insert the anchors (L) into the holes made, and fix the
4
part with the screws (E) and the washers (I).
ø10 mm
Adjust the tilt of the
screen, by loosening
and tightening the
Loosen the screws (D) to rotate
butterflies
the screen. Tight them so that it
stay fixed
Adjust the height by
removing the screws (F)
and the nuts (K)
Level
(1 piece)
M6x40 mm
F(4 pieces)
M8
L (4 pieces)