Dimensions For Reflection Marks - HellermannTyton TT431 Manual De Instrucciones

12 .3 Dimensions for reflection marks

XM
Z
M
L
Dimensions for reflection marks.
1 Materials with reflection marks
2 Virtual material start / reflection mark
3 Continuous material with reflection marks
4 Feed direction
Reflection marks must be on the rear side of the material. Upon request, a light barrier for reflection marks on the front
side can be supplied.
The data is valid for black marks. Colour marks may not be detected. This must be tested in advance.
Dimension
A
AZ
L
M
XM
Z
The detection of reflection markings by the label sensor for
translucent materials is not only possible with the reflection
method but also with the backlight method.
1
A
Name
Material distance
Print zone distance
Width of the reflection mark
Height of the reflection mark
Distance mark - centre of paper feed
Distance virtual material start - actual material start
Operating Instructions • Thermal transfer printer TT431 • 10-2019 • 556-00400
AZ
2
M
Technical data
3
XM XM
L
Dimension in mm
> 2
> 2
> 5
3 - 10
-58 - ±0
0 to A /
Recommended: 0
4
23