Electrical Connection - Angelo Po 0N0FT1G Manual De Uso

Important
The equipment comes with a cable to connect
it to the outlet of the disconnecting switch. If
it is necessary to change the cable, proceed as
described below.
Important
The connection must be made by authorised,
skilled personnel, in accordance with the rel-
evant legal requirements, using appropriate
and specifi ed materials. The appliance is sup-
plied with operating voltage 230V1~N 50 Hz.
For direct connection to the mains one must en-
visage a device that ensures disconnection from
the mains, with a contacts opening distance that
ensures complete disconnection in the condi-
tions of category III over-tension, in compliance
with the installation rules.
Important
Before doing any work, cut off the mains elec-
tricity supply.
Connect the appliance to the mains electricity
supply as follows:
B
D
3269771_inst_GB

ELECTRICAL CONNECTION

C
E
C
If not already present, install an automatic cir-
1)
cuit-breaker
(A)
following characteristics:
– Thermal breaker device (to adjust see table An-
nexes).
– Magnetic circuit breaker curve B (IEC 60898-1).
– Residual current protection set at a 30 mA.
Pull off the knob (B).
2)
Take out the screws(C) and take down the
3)
dashboard (D) to access the electric box (E).
Undo the screws(F) to remove the lid (G).
4)
Connect the automatic circuit-breaker (A) to
5)
the appliance's terminal board
electrical mains supply, in accordance with the
electrical system diagram provided at the back
of the manual and using a cable with the fol-
lowing characteristics:
– Weight: ≥ thanH05RN-F type (designation 245
IEC 57).
– Temperature of use: ≥ 70°C.
Important
When connecting, take care to connect the
neutral and earth lines.
Replace all when the operation is complete.
6)
F
- 11 -
, close to the appliance, with the
and to the
(H)
A
G
IT
GB GB
H
ENGLISH