Connect The Ethernet And Power; Connect The Power Wires - Cognex In-Sight Micro Serie Manual De Instrucciones

Connect the Ethernet and Power

The vision system's PoE connector provides the Ethernet connection for network
communications and supplies power to the vision system.
The following steps illustrate how to connect the In-Sight Micro vision system to the
In-Sight CIO-MICRO or CIO-MICRO-CC I/O module. If neither I/O module is used, a
third-party PoE injector or a PoE switch must be used to supply power to the vision
system.
Note: Refer to the In-Sight
Installation Manual for detailed connection information.

Connect the Power Wires

CAUTION: Never connect the I/O module to a power source other than
24VDC. Any other voltage creates a risk of fire or shock and can damage the
hardware. Do not connect the 24VDC power source to any terminals other
than the 24VDC + and – power connectors.
1. Verify that the 24VDC power supply being used is unplugged and not
receiving power.
2. Use a screwdriver to loosen the I/O module's power terminals (labeled
24VDC + and –).
3. Insert the 24VDC + and – wires (16 - 22 AWG, solid or stranded wire) from
the power supply into the 24VDC + and – terminals on the I/O module.
4. Tighten the screw terminals with the screwdriver to secure the wire leads in
the terminal block; the maximum torque is 0.1921 Nm (1.7 in-lb).
5. Connect a frame ground wire to the I/O module's Frame Ground terminal.
®
CIO-MICRO and CIO-MICRO-CC I/O Module
7