Mounting The Camera - Velleman CAMCOLVC13 Manual Del Usuario

CDROM and double click it. A screen pops up showing date and time; correct
when necessary and click Save, followed by OK. Disconnect the USB cable and
switch the camera on. If setup is successful, then the camera will turn off
automatically by itself in seconds.
• If above procedure fails reconnect the camera to the PC and copy the files
default.exe and default.txt from the manual setup directory to the root
directory of the camera. Edit default.txt and change values (see below):
2 0
4 15790001
1 0
2 2010
2 07
2 26
2 23
2 13
Note: do not make any other changes to the file (e.g. add spaces, remove
lines...)
• Save the file and double click on default.exe.
• Make sure to disconnect the device from the USB port in the appropriate
manner. Close the housing and switch on the camera to complete date and time
setup.
Using the camera
• Press the power button [4] shortly, the camera will automatically begin to
record after 5-10 seconds. A blue LED under the power button flashes. This
indicates that the camera is recording. Press the live record button [5] to stop
recording and put the camera in standby mode.
• When no button is pressed for 3 minutes in Standby mode, the camera will
automatically shut off to save battery power.
• Press the live record button [5] to start recording. The power LED [4] starts
flashing. Press the live record button [5] again to stop recording.
• In standby mode, press the snapshot button [6] to take a snapshot.
• When using the camera in dark circumstances, switch on the LEDs [2] at the
front of the camera by pressing the LED button [7]. Press again to switch the
LEDs off.
• Press the LED flash button [8] to make the LEDs [2] flash. This setting can be
used e.g. as a warning signal.

Mounting the camera

• The camera comes with different mounting brackets for different applications
(see image below): bicycle mount (1), helmet mount (2), elastic strap (3), wrist
strap (4) and clip (5).
7. LED overview
blue, fixed
blue, one flash
blue, flashing slow (±1s)
blue, fast flashing
23.11.2010
CAMCOLVC13
(do not delete or change this value)
(do not delete or change this value)
(do not delete or change this value)
set year (four digitals)
set month (01 ~ 12)
set day (01 ~ 31)
set hour (00 ~ 23
set minutes (00 ~ 59)
standby
snapshot taken
recording video
battery low or memory card full
when battery is low, the camera will switch off
6
Rev. 01
©Velleman nv