Replacing Carbon Brushes; Optional Accessories - Makita 5007N Manual De Instrucciones

Replacing carbon brushes

► 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
2
► 1. Brush holder cap 2. Screwdriver
For model 5007NFA only
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10 min-
utes. Then check the tool while running and electric
brake operation when releasing the switch trigger. If
electric brake is not working well, ask your local Makita
service center for repair.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
•
If you need any assistance for more details regard-
1
ing these accessories, ask your local Makita Service
Center.
•
Combination
Pressure treated/
Wet lumber
Fine cross cuts
•
•
•
NOTE:
•
MAKITA LIMITED WARRANTY
Please refer to the annexed warranty sheet for the
most current warranty terms applicable to this product.
If annexed warranty sheet is not available, refer to the
warranty details set forth at below website for your
respective country.
United States of America: www.makitatools.com
Canada: www.makita.ca
Other countries: www.makita.com
10 ENGLISH
CAUTION:
These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
Steel & Carbide-tipped saw blades
General purpose blade for fast and smooth rip,
crosscuts and miters.
Designed for fast cutting of pressure treated and
wet lumber.
For sand-free cuts cleanly against the grain.
Rip fence (Guide rule)
Hex wrench
Dust nozzle
Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.