Pro Work EURO 2200-1 Manual De Instrucciones página 10

Anleitung Euro 2200-1 Prowork
GB
Read this manual carefully before putting the compressor into operation!
Technical data
Power supply
Motor rating in kW/h.p.
Compressor speed in rpm
Operating pressure in bar
Pressure vessel volume in litre
Theoretical intake rate in l/min.
Sound power level LWA in dB(A)
Sound pressure level LPA in dB(A)
Protection type
Machine weight in kg
Article No.
Identification No.
The machine is radio-suppressed in accordance with EC Guidelines 82/499 EEC.
The unit is not intended for outdoor operation as per Article 3 of EC Directive 2000/14/EC.
Points to note when work is conducted with sprayed
water.
setting up the
compressor
Safety instructions for
working with
Examine the machine for signs
compressed air and
of transit damage. Report any
damage immediately to the paint sprayers
company which delivered the
compressor.
Important! Note the pertinent
Before you put the compressor
accident prevent regulations in
into operation, check the oil
force in your area!
level in the compressor pump.
The compressor should be set
Compressors and lines reach
up near the working consumer.
high temperatures during
Avoid long air lines and long
operation. Avoid contact! Risk of
supply lines (extensions).
burns!
Make sure the intake air is dry
and dust-free.
Gases or vapours drawn in by the
Do not set up the compressor
compressor have to be kept free
in damp or wet rooms.
of constituents that may cause
The compressor may only be
fire or explosions inside the
used in suitable rooms (with
compressor.
good ventilation and an
ambient temperature from +5°
When you disconnect the hose
to +40°C). There must be no
coupling, hold the coupling
dust, acids, vapors, explosive
element in your hand to prevent
gases or inflammable gases in
injury from the whiplashing hose.
the room.
Wear goggles when working with
The compressor is designed to
the blow-out gun. Injuries may
be used in dry rooms. It is
easily result from foreign bodies
prohibited to use the
and blasted parts.
compressor in areas where
10
18.07.2003 11:44 Uhr
EURO 2200-1
230 V ~ 50 Hz
1,5 / 2
2850
8
24
210
97
87
IP 20
31
40.072.53
01033
Never point the blow-out gun at
other persons and never use it to
clean clothes that are still being
worn.
Note the safety
instructions for paint
spraying!
Important! Note the pertinent
accident prevent regulations in
force in your area!
Never process paints or
solvents with a flash point
below 21°C.
Never heat paints or solvents.
It is imperative to use filtering
equipment (face masks) when
processing harmful liquids.
Note also the information
concerning safety precautions
published by the manufacturers
of these liquids.
Seite 10