Select Load Size - Sears Kenmore 2002 Serie Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7.

Select LOAD SIZE

Select the load size setting most suitable for your load. Extra
Small will add a low amount of water for smaller loads and
Extra Large will add the most amount of water for large or
bulky loads. Items need to move freely.
8.
Select WASH TEMP
After selecting the load size, select the Wash Temp by turning
knob to desired temperature. All rinses are tap cold.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
Wash Temp
Hot
Some cold water is added to save
energy. This will be cooler than
your hot water heater setting.
Warm
Some cold water will be added, so
this will be cooler than what your
previous washer provided.
Cool
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
Cold
This is the temperature water temp
from your cold water faucet. If
water is too cold, warm water may
be added to assist in soil removal
and help dissolve detergent.
10
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed
or fade
Light soils
Dark colors that
bleed or fade
Light soils
9.
Select options (on some models)
Select the desired cycle options. If you are using fabric softener,
be sure to select one of the Rinse with Fabric Softener options.
10.
Press START/PAUSE/Unlock Lid
to begin wash cycle
Press the START/PAUSE/Unlock Lid button to start the wash
cycle. When the cycle has finished, the Cycle Complete
status light will light. Promptly remove garments after cycle has
completed to avoid odor, reduce wrinkling, and rusting of metal
hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/PAUSE/Unlock Lid; the lid will unlock once the washer
movement has stopped. This may take several minutes if the load
was spinning at high speed. Then close lid and press START/
PAUSE/Unlock Lid again to restart the cycle.
If lid is left open for more than 10 minutes, the water will pump
out automatically.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido