Metabo HPT UC 18YTSL Manual De Instrucciones página 19

Problem
Charging of a USB device
pauses midway.
Charging of the USB device
pauses midway when the
battery and the USB device
are being charged at the
same time.
Charging of the USB device
doesn't start when the
battery and the USB device
are being charged at the
same time.
AC devices cannot be used
even when they are plugged
into the AC outlets on the
charger.
Devices do not charge even
when they are connected to
the USB ports.
Possible Cause
The charger was plugged into an
electrical socket while the USB device
was being charged using the battery as
the power source.
A battery was inserted into the charger
while the USB device was being charged
using a power socket as the power
source.
The battery has become fully charged.
The remaining battery capacity is
extremely low.
The charger fuse has tripped due to
excessive load from the AC device.
The charger fuse has tripped due to
excessive load from the USB device.
Possible Solution
This is not a malfunction.
The charger pauses USB charging for
about 5 seconds when it is diff erentiating
between power sources.
This is not a malfunction.
The charger pauses USB charging for
about 5 seconds while it checks whether
the battery has successfully completed
charging.
This is not a malfunction.
When the battery capacity reaches a
certain level, USB charging automatically
begins.
Contact a metabo HPT Authorized Service
Center for repairs.
AC devices should not exceed a total of
10 A.
Contact a metabo HPT Authorized Service
Center for repairs.
USB devices should not exceed a total
of 2 A.
English
19