Dräger X-dock 5300 Instrucciones De Uso página 28

Use
If Test schedulermode is activated:
If necessary, log user out on the station (see chapter 4.5 on

page 23).
The preset test is performed according to the configured

time schedule.
Test passed:
Confirmation is shown on the display.

The Status LED flashes green.

If required, select the desired instrument field for additional

information (e.g. test date and performed tests).
Remove the instrument from the module.

WARNING
!
Prior to each use of the gas detector, check whether it
is switched on and in measuring mode after removing
it from the X-dock. Otherwise the user may carry a
device that is switched off!
Test passed, with reservations:
This state means that partial tests of the favourite could not be
conducted due to special settings.
Confirmation is shown on the display.

The status LED flashes yellow.

28
0 0
01033286.eps
0 0
01133286.eps
If required, select the desired instrument field for additional

information.
Remove the instrument from the module.

WARNING
!
Prior to each use of the gas detector, check whether it
is switched on and in measuring mode after removing
it from the X-dock. Otherwise the user may carry a
device that is switched off!
Test not passed:
An error message is shown on the display.

The Status LED flashes red.

If required, select the desired instrument field for additional

information.
Identify and rectify the error.

Repeat the test if necessary.

Overview of status LEDs
Colour Status
blue flashing
green flashing
yellow flashing
red flashing
0 0
01133286.eps
Meaning
Process in progress
Test passed
Test passed,
with reservations:
Test failed/cancelled
Dräger X-dock 5300/6300/6600