General Installation Requirements - Sinmag Europe MANOTRAD Manual Del Usuario

personnel.
10. Do not use water jets or spray to clean the machine.
11. When sharp accessories are manipulated, use cut-resistant gloves.
3. INSTALLATION

3.1 GENERAL INSTALLATION REQUIREMENTS

NOTE:
It is most important that this machine is installed correctly and that the operation
is correct before use. Installation shall comply with local fire, health and safety
requirements.
This machine is designed to provide years of satisfactory service. Correct installation is
essential to achieve the best performance, efficiency and trouble-free operation.
3.2 INSTALLATION
This machine shall be installed with sufficient ventilation to prevent the occurrence of
unacceptable concentrations of health harmful substances in the room.
Installations must be carried out by qualified service persons only. Failure to install equipment
to relevant codes and manufacturer's specifications in this section will void the warranty.
Components having adjustments prevented (e.g. paint sealed) by the manufacturer are
only to be adjusted by an authorised service agent. They are not to be adjusted by the
installation person.
3.3 UNPACKING
On receipt of the machine, carry out the following: Remove all packaging and transit
protection including all protective plastic coverings from outer panels.
Check equipment and parts for damage. Report any damage immediately to the carrier and
dealer. Never attempt to operate the machine with damaged parts.
Report any deficiencies to the dealer that supplied the machine.
3.4 LOCATION
1. Select a location for the machine with a minimum of 0.6m space around the machine for
operating, cleaning and servicing.
2. Position the machine in its proper working position. The machine must be installed on a
flat, solid and dry floor.
3. It is recommended that the machine is level from front to back and from side to side. This
will ensure the greatest stability.
ENG
11