Culligan US-2 Instrucciones De Instalacion Y Uso página 5

3
Insert spout into faucet body approximately 3/4"
until it stops, ensuring both o-rings are in faucet
body. Guide the black rubber gasket onto the
threaded faucet stem. Lower faucet stem through
hole in sink. Make sure the faucet sits flat on top
of the sink or countertop surface.
5
Turn off cold water shut-off valve then turn on
the kitchen faucet and allow all water to drain
from line.
4
From underneath the sink, guide the metal lock
washer onto stem, then screw the plastic faucet
stem nut all the way up the faucet stem and
tighten with fingers to secure faucet to sink.
Remove spare battery and put inside the slot just
below the Culligan logo (positive side facing out).
6
Disconnect the cold water line from the
cold water shut-off valve.
NOTE: If rigid plumbing pipe (metal or plastic)
is used, you may need to shorten the pipe using
a hacksaw or pipe cutter to accommodate the
water supply adapter.
5