Inserting / Replacing The Batteries; Use And Functions - KLAN DUALPOWER K-DP-GLV Serie Instrucciones De Uso

EN

INSERTING / REPLACING THE BATTERIES

If the batteries are no longer fully functional (reduced heating times;
battery fails to recharge), it is necessary to replace them.
To replace the batteries, proceed as follows:
1. Open the batteries pocket on the glove (1.5).
2. Disconnect the battery cable (1.3) from the glove (1.4).
3. Remove the batteries and replace them with new ones. Dispose
of the old batteries properly.
4. Connect the battery cable to the glove and close the pocket.

USE AND FUNCTIONS

The Dual Power glove has four operating modes:
POWER-OFF - LEVEL 1 - LEVEL 2 - LEVEL 3 - LEVEL 4. These are
clearly visible heating level display (1.1) - The corresponding LED
color refers to the selected Level.
The Dual Power glove has a control pad with one control button
(1.2) to set the 4 levels of heating. These can be used to choose
between 4 different heat levels. The Dual Power glove is switched
off when the LED display is not lit.
Turning the device on:
Turning the device off:
Manual adjustment:
with a lengthy press of the control button (3
sec.) the Dual Power glove is activated to the
highest heating level.
with a lengthy press of the control button (3
sec.) the Dual Power glove is getting off, no
LED marked.
Each time the control button is pressed , the
heat level is increased, White led minimum
level , Blue led medium level , Violet led high
level, Red led maximum level. With a new
pressure the glove returns at the minimum
level.
10