Installation - Eurofred S/S Counters Serie Manual De Instrucciones

Safety tips
26. For indoor use only. Not suitable for installation in an area where a water jet could be used.
Must not be cleaned by a water jet.
27. To guarantee safe operation, ensure that the appliance is set up and connected as described in
the instruction manual.
28. Any repairs and work on the appliance should only be carried out by the customer service
department.
29. The key to the electrical cabinet should be kept out of the reach of children and users.
30. Do not store explosive substances such as aerosol cans with a flammable propellant in this
appliance.

Installation

• Remove the appliance from the packaging. Make sure that all protective plastic film and coatings
are thoroughly removed from all surfaces. To prevent injury or damage to the unit, we recommend
that the appliance should be unpacked and set up by two people.
• Maintain a distance of 20cm (7 inches) between the appliance and walls or other objects for
ventilation. Increase this distance if the obstacle is a heat source.
• The appliance should be placed on a solid level floor to reduce noise and vibration. Level the
appliance by adjusting the screw feet.
• The temperature in the place where the COUNTER is located must be between 10°C and 32°C
(Climatic Class 4). Avoid locating it indirect sunlight or near heat source such as an oven or a radiator.
• Please make sure the appliance is properly ventilated.
• Check that the power supply and voltage used comply with the details on the rating plate. The plug
must be accessible after installation.
• Correctly connect and disconnect the plug. When inserting ensure the plug is fully engaged. When
unplugging do so so by holding the body of the plug. Never pull the supply cord directly.
• If the COUNTER is to be shut down for long period, switch it off and disconnect the plug from socket
outlet. Clean the appliance and leave the door lid open to prevent odor.
• Important! For your personal safety, this appliance must be properly grounded (earthed). This
appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be
inserted into an outlet that is properly grounded and installed. Consult a qualified electrician or
service center if you do not completely understand the grounding instructions. If doubt exits as to
whether the appliance is properly grounded, have a qualified electrician check the circuit to make
sure the outlet is properly grounded.
• If the cable does not reach the nearest socket, either rearrange your store layout or ask a qualified
electrician to fix a new socket.
• If power is cut off, wait for at least 3 minutes before restarting the appliance to avoid damaging the
compressor.
• Do not place any appliance such as microwave oven, toaster, etc, which give off heat on the
appliance.
GB 4 P2M026STD-Ver1.1