ELECTROCOMPANIET ECI 3 Manual De Instrucciones página 5

Replacing a blown main fuse
The main fuse is located in a small drawer inside the AC inlet of the unit.
If, for some reason the fuse is blown, turn the unit off, and remove the AC cord from the AC inlet.
Open the drawer with a small screwdriver and remove the blown fuse.
The spare fuse is located inside a holder in front of the main fuse.
1. Remove the spare fuse gently by pushing it sideways out of its holder.
2. Insert the spare fuse as the active fuse.
3. Push the drawer gently back to closed position.
4. Re-insert the AC cord and turn the unit on.
Never replace the fuse with other values than indicated on the unit!
Replacing remote control batteries
Replace used batteries by gently inserting your fingernail or small screwdriver in the groove on
the left side of the battery compartment cover.
Lift the cover off, and insert a fresh set of batteries.
Be careful to follow the + and – polarity indications at the bottom of the battery compartment.
Battery: 2 x LR03 / AAA: 1.5Volts
Input configurations
XLR input: 1 = ground 2 = positive 3 = negative
RCA:Center = positive Circle = ground.
Output configurations
XLR output:1 = ground 2 = positive 3 = negative
Speaker: Red = positive Black or White = ground
RCA to XLR adapter: ECP5XLR ; ground and negative = shorted. 2 = positive
Diagram 4
Diagram 2
Diagram 6
Diagram 6 and 1
4
GB USA