Publicidad
Idiomas disponibles
Idiomas disponibles
K
M
Operation / After use
Electronic brush and suction power control
Model 17-30, 17-46
After switching on the appliance and tilting the guiding
tube, the GREEN power-on indicator [K] lights up.
In case of extreme overloading of the brush motor
(e.g. if the roller is blocked), the electronic overload de-
vice is triggered: Overload indicator [M] lights up RED
and GREEN goes out. In this case, first switch off and
unplug the appliance. Eliminate blockage and after
waiting about one minute, switch on the appliance again.
NOTICE!
If the filter and/or suction paths are permanently
blocked, the automatic overload switch on the suction
motor will automatically switch off to prevent overheat-
ing. After a cool-down period of about 20 minutes, you
can switch the appliance on again.
Opening the canister (dust compartment)
To replace the filter or dust bag, push up the latch to
open the front of the canister (dust compartment).
Lid closing stop
The lid closing stop prevents the lid from closing and al-
so prevents operation of the appliance without a dust bag
or when the dust bag is inserted incorrectly.
Replacing the dust bag
Open dust compartment and remove full dust bag. Place
new dust bag on the orifice in the canister and push back
as far as it will go.
GB
33
Publicidad
Capítulos
