Specifications - Duralast DL-15D Manual Del Usuario

Troubleshooting
PROBLEM
Battery clamps do not
spark when touched
together.
Three LEDs come on
for 2 seconds, then
turn off.
The charger will not
turn on when properly
connected.
I cannot select a 6V or
12V setting.
The display shows
"bAD / bAt / F01 ".
The display shows
"SUL".
The display shows
"bAD / bAt / F02".
The display shows
"bAD / bAt / F05".

14. SPECIFICATIONS

Input Voltage ..................................................................................120V AC @ 60Hz, 3.6A
Output Voltage .......................................................6V or 12V, with Auto Voltage Detection
Output Current Rating .......................................................... 2A @ 6V DC; 15A @ 12V DC
POSSIBLE CAUSE
The charger is equipped
with an auto-start feature.
It will not supply current to
the battery clamps until a
battery is properly connected.
The clamps will not spark if
touched together.
The charger is plugged into an
AC outlet.
AC outlet is dead.
Poor electrical connection.
Battery is defective.
The charger is equipped
with Auto Voltage Detection,
which automatically detects
the voltage and charges the
battery.
The battery voltage is still
below 10V (for a 12V battery)
or 5V (for a 6V battery) after 2
hours of charging.
The charger has detected a
sulfated battery.
Desulfation was unsuccessful,
after 10 hours.
Lack of progress is detected
after 12 hours in Maintain mode.
No problem; this is a normal
condition.
No problem; this is normal.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and extension
cord for loose fitting plug.
Have battery checked.
No problem; this is normal.
The battery may be defective. Make
sure there are no loads on the
battery. If there are, remove them.
If there are none, have the battery
checked or replaced.
The charger will go into desulfation
mode. If the desulfation is not
successful after 10 hours, the
charger will go into abort mode.
The battery may be defective. Have
battery checked or replaced.
The battery won't hold a charge.
May be caused by a drain on the
battery or the battery could be bad.
Make sure there are no loads on the
battery. If there are remove them.
If there are none, have the battery
checked or replaced.
• 9 •
SOLUTION