Installing A Special Shape Cover - BSVILLAGE Grille COLD Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
11/36 - Installation & user manual for Grille COLD
2.1.2 Drilling the end anchoring
Fig 3
- - When using ordinary anchors: Using the 7 mm drill bit, drill the deck while
sloping the drill 45° towards the outer edge and drill to a depth of at least
10 cm.
Drill hole for an
ordinary anchor
Fig 3
Fig 4
- - For anchor-inserts: using the 10 mm drill bit, drill the deck while keeping the
drill perpendicular to the ground and drill to a depth of at least 10 cm.
Drill hole for an
anchor-insert
Fig 4
Fig 5
- - For wood anchors: using the 12 mm wood drill bit, drill the deck while
keeping the drill perpendicular to the ground and drill to a depth of at least
2.7 cm and fix the anchor using the 3 screws provided.
Drill hole for wood
deck anchor
Fig 5
Fig 6
- - Drill the deck in the cover corners (along the drill line) starting on the storage
side. 8 drill holes are needed.
- - Install the anchors.
Fig 6
2.1.3 Positioning the cover
Fig 7
- - Carry the cover next to the pool and unroll on one width so that when
unrolled, the label is on the top of the cover.
- - Fit the bungees in the straps on 2 corners of one end of the mesh and fix the
ends around the anchors.
safety covers
®
Cover
45°
Cover
Cover
Anchor drill hole line
Cover dimensions
Drill holes
0.51 m
Fig 7
Fig 8
- - Fit the springs onto the straps on the other 2 corners, pick them up, stretch
the cover over the pool and fix them to the anchors.
Fig 8
2.1.4 Drilling all the anchorage
- - Make sure the cover is properly positioned and drill all the required holes
opposite each pair of straps (along the drilling line).
- - Fit the bungees and stretch them around the anchors (see § 2.1.3).

2.2 Installing a special shape cover

Fig. 9
Carry the cover next to the pool and unroll on one width so that when
unrolled, the label is on the top of the cover.
Fig. 9
2.2.1 Positioning the cover
Your cover is the same shape as your pool.
- - Unroll the cover over the pool and centre it so that the overlaps are even.
- - Keep the cover in place using weights. Check that the cover covers the entire
pool and is perfectly centred.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido