Care & Maintenance; Care; Maintenance; Special Specifications During Winter - BSVILLAGE Grille COLD Manual Del Usuario

13/36 - Installation & user manual for Grille COLD
WARNING
• The cover is tested on the coping: You must make sure that all protuberances
are eliminated when installing the cover.
• Caution, safety is only provided by a closed, locked cover which is properly
installed in compliance with our instructions.
• This cover is not a substitute for common sense or personal liability. It does
not aim to replace the vigilance of parents and/or responsible adults, which
remains the essential factor in the protection of young children.
• This cover should never be considered to be a walking area: as a result
never intentionally climb onto, walk on or jump on the safety cover!
5. Care & maintenance

5.1 Care

You should clean your cover as soon as it is liable to affect pool water quality.
Routine cleaning is basic cleaning using a hose. Always avoid aggressive or
foaming products, solvents and abrasive sponges. Covers should not be
cleaned when installed over the pool.

5.2 Maintenance

The cover and fixing elements should be inspected at least once per year (for
example when the cover is cleaned).
Additional checks are required if the safety function of the cover has been
used, or after a period in which it may have been subjected to extreme
conditions (storms, heavy snow, etc.).
Following these various checks, it is essential to change all damaged parts
and not hesitate to immediately replace any component that has any
defects or signs of wear. When in doubt, contact your pool professional.
All spare parts must be manufactured by ALBON in order to maintain the
original cover specifications.
IMPORTANT
If the cover is altered or if a malfunction prevents the pool from being
covered and secured, take all necessary steps to prevent young children from
accessing the pool until the cover has been repaired.
The after sales service is firstly provided by your dealer.
For all other information, ALBON is available at the following phone number
+33 4 75 31 07 07.

5.3 Special specifications during winter

GRILLE Cold will give full satisfaction when used in winter subject to
®
following the rules given below:
- - The pool water level must imperatively be kept at use height (2/3 over the
skimmers), make sure the water does not overflow and pass behind the liner
(use of an overflow) and make sure that embedded parts and piping do not
freeze (use of gizzmos, suitable caps and a line of winterisation floaters).
- - Maintaining the water level allows the cover to be supported by the water in
the event of heavy precipitation. In excess of 10 cm of snow, the snow must
be cleared from the cover.
IMPORTANT NOTE
Failing to maintain the water level will void the warranty on GRILLE Cold
covers.

6. Guarantee

CAUTION
The GRILLE Cold covers have a 3 year warranty for normal use.
®

6.1 Use and warranty conditions

- - As GRILLE Cold covers are made to measure, we cannot be held liable for
®
any errors in the dimensions or colour communicated by the customer.
- - GRILLE Cold covers must be installed and used according to the contents of
®
this manual.
- - All complaints must be sent by registered letter with acknowledgement of
receipt and the equipment in question made available to our experts or to
those of our insurance companies for expertise. No GRILLE Cold
be returned without our prior permission and must be accompanied by a
filled in "Return form" (exact reason for the return).
- - The after sales service is firstly provided by your pool dealer.
- - Parts will only be replaced once the defective part has been received.
safety covers
®
covers can
®

6.2 Exclusions from the guarantee

The guarantee is not applicable to:
- - Incorrect assembly, failure to follow the installation instructions and the
resulting damage.
- - Incorrect operation or abnormal use and the resulting damage.
- - The normal wear of cover components.
- - Wear and damage caused by abnormal friction.
- - Wear from abrasion on rough, abrasive or curved coping. Excess snow
(maximum 10 cm, see § 5.3).
- - Strong wind and violent hail storms.
- - Damage due to transport.
- - Cleaning using products other than those that are recommended (see § 5.1).
- - Use of spare parts not manufactured by ALBON.
CAUTION
All covers that have not been fixed in strict compliance with the installation
instructions will not be covered y the guarantee.
NOTE
• This guarantee only covers the replacement of parts or units that are
acknowledged to be defective, and excludes any liability, compensation or
transport costs for any reason whatsoever.
• This guarantee only applies after full payment of the invoice for the product
in question.
• All covers for which there is a disagreement must be returned carriage paid,
with our permission, for expertise.

6.3 French Consumer Code

Article L 211-4: - the vendor is required to deliver a product which conforms
to the contract and is held liable for any lack of conformity which exists
upon delivery. They are also liable for any lack of conformity caused by the
packaging or the assembly instructions, or the installation if they have taken
responsibility for it or had it carried out under their responsibility.
Art L 211-5: to be compliant with the contract, the product must:
- - Be fit for the purpose usually expected of such a product and, if applicable:
•-Correspond to the description given by the vendor and have the features
that the vendor presented to the buyer in the form of a sample or
model;
•-Have the features that a buyer might reasonably expect it to have
considering the public statements made by the vendor, the
manufacturer or their representative, including in advertising and
labelling;
- - Or have the features defined by mutual agreement between the parties or
be suitable for any special requirement of the buyer which was made known
to the vendor and which the latter agreed to.
Art L 211-12: Action resulting from lack of conformity lapses two years after
delivery of the product.

6.4 French Civil Code

Art 1641: The vendor is bound to provide a guarantee for hidden defects
®
of the sold object which render it unfit for the purpose for which it was
intended, or which so impair that use that the buyer would not have
purchased it, or would only have paid a lower price for it, had they known
of them.
Art 1648: The action resulting from redhibitory defects must be brought by
the buyer within a period of two years following the discovery of the defect.
In the case defined by article 1642-1, the proceedings must be brought
during the year following the date on which the vendor can be released from
visible defects in order to avoid foreclosure.
13