Svan SVI631FZ Instrucciones De Uso Y De Instalacion página 28

Booster and double booster function
Booster [ P ] and double booster [
If this function is activated the heating zones work during 10 minutes with an ultra-high power.
This is foreseen for example to heat up rapidly big quantities of water, like noodles
•
Start up / Stop the booster:
Action
Start up the booster
Stop the booster
•
Start up / Stop double booster
Action
Start up the booster
Start up double booster
Stop the double booster
Stop booster
•
Power management:
When it comes to the power, the cooking zones are running by pairs and cannot exceed an
overall maximum of power. If the selected heating levels for both zones exceed the maximum
available amount of power, the power management function is automatically reducing the power
from one of these zones. The display of this zone is first blinking; the level is then automatically
reduced to the highest suitable position.
Heating zone selected
[ P ] is displayed
Timer
The timer is able to be used simultaneous with all heating zones and this with different time
settings (from 0 to 999 minutes) for each heating zone.
•
Setting and modification of the cooking time:
Action
Select the power level
Select theTimer
Decrease the time
Increase the time
After a few seconds, the [ min ] display stops with blinking.
The time is confirmed and the timer starts.
•
To stop the cooking time:
Action
Select the Timer
Stop the time
If several timers are activated, repeat the process.
] grant a boost of power to the selected heating zone.
Control panel
Slide to the end of the "SLIDER"
Or press directly on the end of
the "SLIDER"
Slide on the "SLIDER"
Control panel
Slide to the end of the "SLIDER"
Or press directly on the end of
the "SLIDER"
Re-press key [ P ]
Slide on the "SLIDER"
Slide on the "SLIDER"
The other heating zone: (example: power level 9)
[ 9 ] goes to [ 8 ] and blinks
Control panel
slide on the "SLIDER"
Press simultaneously key [ - ] and [ + ] Timer display on
from the timer until the
desired display is on
Press key [ - ] from the timer
Press key [ + ] from the timer
Control panel
Press simultaneously key [ - ] and [ + ] Timer display on
from the timer until the
desired display is on
Press key [ - ] from the timer
28
Display
[ P ]
[ 9 ] to [ 0 ]
Display
[ P ]
[ and P ]
[ P ] to [ 0 ]
[ 9 ] to [ 0 ]
Display
[ 1 ] to [ P ]
[ 60 ] to 59, 58...
Time increase
Display
[ 000 ]