Gigacam - Marmitek GIGACAM 4 Manual De Instrucciones

4. GIGACAM 4 WIRELESS CAMERA
1. Camera lens
2. Microphone
3. Channel indicator
4. 2.4 GHZ antenna
5. Cover for the channel switch
6. Connection for the power adapter
7. Wall bracket
8. IR LEDs for night view (only with the optional 'wireless black/white camera with night
view', see chapter 8)
4.1. HOW TO ACTIVATE THE CAMERA
1. Screw the 2.4 GHz antenna, included in the set, into the back of the camera. Place the
antenna in an upright position.
Antenna connector
2.4 GHz antenna
2. Transmitter and receiver have to be set to the same channel. The factory setting of the
camera is Camera Channel 1. Normally, you do not need to change this setting. If the
camera suffers from interference, you can switch both the camera and receiver to
another channel. The switch for the channel setting can be found under the rubber cover
on the back of the camera.
4
8
1
3
2
© MARMITEK