Technical Data - Marmitek IR CONTROL PRO 8 Manual De Instrucciones

• The IR Receiver does not work together with some A/V apparatus and models which use
a higher IR frequency like for instance Bang&Olufsen (B&O) .
• Sometimes it may be that the IR Receiver is troubled by so-called interference (direct
sunlight, TL lighting, energy saving lamps etc). In that case you ought to re-direct the IR
Receiver a bit for a better result.
Can I use the IR Receiver near a flat screen TV ?
The IR Receiver is 'Plasma proof', however, sometimes it may happen that the IR receiver
suffers some disturbance from the TV screen. Then move the IR receiver in such a way that it
is not in the direct radiation of the Plasma TV. It is easy to test. The LEDs are so-called blinking
LEDs. When they transmit an IR signal they blink. When you put the IR receiver in front of the
screen the LEDs can lighten up red. When you keep the IR Receiver away from the screen the
LEDs will go out. When the LEDs are out, you have found the correct position to prevent
interference.
Do you have questions that were not answered in the above mentioned ?
Then look at www.marmitek.com.

5. TECHNICAL DATA

IR Module
Feed POWER:
Feed STATUS:
IR LEDs connections:
IR Receiver connection:
Dimensions:
IR receiver built-on
Frequency range:
IR reception range:
Length of cable:
IR receiver:
IR reception angle:
Dimensions receiver bloc:
IR receiver built-in (optional)
Frequency range:
IR reception range:
Length of cable:
IR receiver:
IR reception angle:
Dimensions receiver:
IR CONTROL PRO 8
230VAC/50Hz, 12VC 500mA (supplied).
12VDC 200mA. Plug, - 5.5 mm outside / + 2.1 mm
inside (not supplied).
4 x 3.5 mm jack plug (mono).
1 Connector for maximal 3 parallel connected receivers.
85x49x24xmm (fastening points inclusive).
34-40 KHz.
± 10 metres.
2 metres, extendable to max 300 metres (UTP or equivalent).
Reception indication LED + Status indication (Blinking LED).
90° (+45°/-45° from centre).
47x10x14mm.
34-40 KHz.
± 10 metres
2 metres, extendable to max 300 metres (UTP or equivalent).
Reception indication (Blinking LED).
90°(+45°/-45° from centre)
Diameter 11.7 mm - Drilling size 12 mm - Length 50 mm
Built-in depth 55 mm - Maximal thickness of material 40 mm.
TM
Orange
Blue
Purple
Yellow
Black
Black
White
7