2
Details about the MCM10 module
Heating controller on
MCM10 master
module
1
Modulating weather-
compensated heating
controller with EMS BUS
control.
2
Modulating 0 - 10 V
controller, regulates acc. to
0 ... 10V
output.
3
Modulating 0 - 10 V
controller, regulates to flow
0 ... 10V
temperature.
4
Heating control unit with
ON/OFF contact.
Tab. 6 System versions overview
System version 1:
Modulating weather-compensated heating
controller with EMS BUS control
One benefit of this system version is the ability of the
modules to communicate to enable heating circuits to be
regulated (WM10 and MM10 function modules) with the
MCM10 module via a common BUS, parallel to
connection J on the MCM10 module (
This ensures optimum matching of the generated amount
of heat to the actual heat demand of all heating circuits in
the heating system. With this version, the heating system
achieves optimum comfort with maximum energy savings.
62
Type
Required accessories with connection to MCM10 (
RC35
4
16
•
Outside temperature sensor.
•
WM10 low loss header module. The flow temperature sensor (part of the
standard delivery of the WM10) is connected to the WM10 low loss header
module.
•
The heating circuit pump is connected to the WM10 module.
any
4
16
•
Common flow temperature sensor (accessory) on terminals E (only for
internal frost protection function).
•
Heating circuit pump (secondary circuit) (
with one or several heating circuits without heating circuit pump or with
heating circuits that are not regulated via the building management system.
any
4
16
•
Common flow temperature sensor (accessory) on terminals E.
•
Heating circuit pump (secondary circuit) (
with one or several heating circuits without heating circuit pump or with
heating circuits that are not regulated via the building management system.
any
4
16
•
Common flow temperature sensor (accessory) on terminals E (only for
internal frost protection function).
•
Heating circuit pump (secondary circuit) (
fig. 3, page 59).
fig. 3, page 59)
fig. 3, [19]) on terminals C, only
fig. 3, [19]) on terminals C, only
fig. 3, [19]) on terminals C.
MCM10