Premium PWA1210G Manual De Usuario página 5

Controls
Power Pad
Turns air conditioner on and off. When
turned on, the display will show the room
temperature.
Display
Shows the room temperature or time
remaining on the Delay timer. Shows the Set
temperature while setting the temperature in
Cool or Energy Saver modes. The Set light will
turn on while setting.
NOTE: The display will change to show the
room temperature after settings have been
made. To recall the Set temperature, press the
Temp Increase L or Decrease M pads.
L
Temp Increase /Decrease
Use to set temperature when in Cool or Energy
Saver mode. The Set light will turn on while
setting.
Delay Timer Increase L (+) /Decrease M (–)
Pads
Each touch of the Increase L / Decrease M
pads on the unit or the Increase
pads on the remote control will set the delay
time when using the Delay 1–24hr timer (
The Set light will turn on while setting.
Fan Speed Pads
Use to set the fan speed to Low, Med, High
or Auto on the unit. NOTE: On the remote
control, use the fan speed Increase
–
Decrease pads to set the fan speeds to Low,
Med or High. Use the Auto pad to turn Auto
fan on.
Remote Control
I
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
I
The remote control signal has a range of
up to 20 feet.
Mode Pad
Use to set the air conditioner to Cool, Energy
Saver or Fan Only mode.
Delay Pads
Delay ON—When the air conditioner is off, it
can be set to automatically come on in 1 to 24
hours at its previous mode and fan settings.
Delay OFF—When the air conditioner is on,
it can be set to automatically turn off in 1 to
24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or
the
of the Increase L / Decrease M pads on the
M
Pads
unit or the Increase
the remote control will set the timer in
1-hour intervals. The Set light will turn on
while setting.
To review the remaining time on the Delay
1–24hr timer, press the Delay 1–24hr pad on the
unit or the
the Increase L / Decrease M pads on the unit
+ –
/ Decrease
or the Increase
).
remote control to set a new time if desired.
To cancel the timer, press the Delay 1–24hr pad
on the unit or the
control.
+
/
I
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
I
Make sure batteries are fresh and installed
correctly as indicated on the remote control.
pad on the remote control. Each touch
+ –
/ Decrease
pad on the remote control. Use
+ –
/ Decrease
pads on the
on the remote
pad
pads on
3