Controls & Functions - BST DSP12A Manual De Instrucciones

4 • DSP12A / DSP15A • EN
CONTROLS & FUNCTIONS
1. MIC/LINE INPUT SECTION
The female XLR connector in this section accepts
balanced MIC or LINE level signals. By using the
LINE/MIC switch, it is possible to adapt the gain to
the microphone or line level signal.
The LEVEL knob allows to adjust the input signal
level.
The THRU connector (male XLR type) produces
exactly the same signal that arrives at the input.
You can use it to daisy-chain several DSP speakers.
NOTE: Please note that the input connector does
not supply + 48V phantom power, so you can use
condenser microphones only if they are self-powe-
red.
2. LINE 2 INPUT SECTION
This section includes 2x 6.35mm jacks (L/MONO, R)
to connect music instruments, mixers etc. The input
audio signal can be adjusted via the relative knob.
3. LINE 3 INPUT SECTION
This panel section includes:
• One 3.5mm mini jack connector for the connec-
tion of mobile phones, tablets, computers, etc.
• Two unbalanced inputs for RCA pin jacks that
can be used to connect any external stereo de-
vice such as MP3 player, CD player, mixer, etc.
• One knob to adjust the input audio signal.
Note: The mini-jack and RCA stereo inputs cannot
be used at the same time.
4. LINK OUT SECTION
The audio signals from the «LINK OUT» XLR
connector are sent (routed from each INPUT) to a
connected speaker. They are line level signals and
therefore, the MIC LINE switch must be set to the
LINE position on the connected speaker.