Purpose And Intended Use - MIRKA 9MRK 8999000111 Instrucciones De Manejo

en
We reserve the right to make changes to this manual without prior notice
Important
Read these safety and operating instructions carefully before installing, operating or maintaining this tool Keep these
instructions in a safe, accessible location

Purpose and intended use

Besides the operating instructions and the binding accident prevention regulations valid in the country of use, observe
recognized regulations for safety and proper use
The dust extractor must
• only be used by persons, who have been instructed in its correct usage and explicitly commissioned with the task of
operating it
• only be operated under supervision
The dust extractor is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge
Children should be supervised to ensure that they do not play with the dust extractor
The dust extractor described in this operating manual are suitable for
• sucking up dust and liquids
• dust suction for handheld power tools
• separation of dust with an exposure limit of greater than 1 mg/m³, (dust class L) Please observe regulations valid in
your country
The following materials should not be picked up by the dust extractor
• hot materials (burning cigarettes, hot ash, etc )
• flammable, explosive, aggressive liquids (e g petrol, solvents, acids, alkalis, etc )
• flammable, explosive dust (e g aluminum, magnesium dust, etc )
The dust extractor must
• be protected from rain and wet conditions other than picking up liquids
• be protected against UV radiation
Before start-up (A)
The fleece filter bag is pre-installed in the dust extractor
Ensure that the voltage shown on the rating plate corresponds to the voltage of the local mains power supply It is
recommended that the dust extractor should be connected via a residual current circuit breaker
Inspect power cord regularly to detect signs of damage, e g cracks or ageing If the power cord is damaged, it must be
replaced by a Mirka service center or an electrician to avoid danger before use of the dust extractor is continued Use
only the type of power cord specified in the operating manual
As an extension lead, only use the version specified by the manufacturer or one of a higher quality When using an
extension lead, check the minimum cross-sections of the cable:
Cable length
< 20 m
20–50 m
36
Mirka® Dust Extractor • 1025 L
Cross section < 16 A
1 5 mm²
2 5 mm²
Cross section < 25 A
2 5 mm²
4 0 mm²