MIRKA 9MRK 8999000111 Instrucciones De Manejo página 37

Only use the dust extractor if it is in undamaged condition Never use the dust extractor without a filter, or if the filter is
damaged It is recommended always to use filter bag for dry applications
When dust extractors are used, the rate at which air is exchanged in the room must be adequate if the exhaust air from
the dust extractor is blown into the room (please observe regulations valid in your country)
Before starting work, the operating staff must be informed on
• use of the dust extractor
• risks associated with the material to be picked up
• safe disposal of the picked up material
Operation (A)
Mirka® Dust Extractor 1025 L
Picking up liquids (B)
Before liquids are picked up, always remove the filter bag Check that the float works properly If foam develops or
liquid emerges, stop work immediately and empty the dirt tank
Cleaning the filter element (C)
If suction performance drops:
1 Switching on the dust extractor
2 Close the nozzles or suction hose opening with the palm of your hand
3 Press the button to start filter cleaning for at least three times for two seconds each The resulting stream of air
removes attached dust from the slats of the filter elements
4 If the suction power is too low after filter cleaning: replace filter
Blower function (D)
The dust extractor has a blower function to clean inaccessible places or to dry the surface of wet items
Do not direct the air into rooms in an uncontrolled manner When using the blower function, always use a clean hose
Stirred-up dust can be hazardous to health Do not use the blower function in closed rooms
Connecting electrical machines (E)
Use the socket on the dust extractor for the purpose defined in the operating instructions only
CAUTION! Follow the operating instructions and safety instructions for machines connected to the power tool socket
Before plugging a machine into the dust extractor socket:
1 Switch off the dust extractor
2 Switch off the machine to be connected
Maintenance, cleaning and repair (F+G)
Only carry out maintenance work described in the operating instructions Always pull out the mains plug before
cleaning and maintenance of the dust extractor Never spray water on to the upper section of the dust extractor
Danger for persons, risk or short-circuiting
The use of non-genuine spare parts and accessories can impair the safety of the dust extractor Only use spare parts
and accessories supplied by Mirka Ltd
During maintenance and cleaning, handle the dust extractor in such a manner that there is no danger for maintenance
staff or other persons
Switch position
I
0
AUTO
Function
On
Off
Auto on/off
Mirka® Dust Extractor • 1025 L
en
37