English
1) VISOR
We recommend that you carry out the following tasks with the helmet resting on a level surface.
12
THIS HELMET'S SHELL IS MADE OF THERMOPLASTIC RESIN
THIS HELMET'S LINER IS MADE OF POLYSTYRENE (EPS)
1.1) Visor mechanism
Upper catch seating
Teeth on visor mechanism base
Visor lock
Visor lock slider
1.2) Removing/fitting the visor
The non-scratch polycarbonate visor is fitted with catches which click into the
visor mechanism base. The visor tooth interact with the teeth on the mechanism
base to provide stability when the visor is open in different positions.
Upper catch
Visor tooth
Lower catch
1
3
K-3 SV
To remove the visor, raise it to the fully open position
(1). Start on one side of the helmet by pulling the visor
lock slider (2) downwards and detach the catches from
the visor. Repeat on the other side and remove the
visor.
To fit the visor, start on one side of the helmet with
the visor fully raised and insert the upper catch into its
seating on the mechanism base (3). Next, insert the
2
visor lower catch into the visor lock (pulling the slider
downwards may help) (4). Repeat on the other side of
the helmet. Lower the visor and make sure it is working
properly.
N.B. It the visor does not line up properly with the
rubber seal on the helmet, you may need to adjust
or replace the visor mechanism base. In such case,
contact AGV for assistance.
4