Safety Tips - Beper RI.312 Manual De Instrucciones

Gas heater Use instructions

SAFETY TIPS:

Do not move the heater while it is in use.
Always face the heater towards the center of the room.
Use it only in a well­ventilated room. Ventilated is vital for the efficient performan­
ce of this heater and for safety of the occupants of the room in which it is being
used. Allow plenty of fresh air in, never seal up the doorways and windows.
Prevent young children and elderly people from touching very hot surfaces.
The normal dress guard only protects against accidental clothing contact.
Do not place clothes or other material on the heater. Keep all flammable materials at least
one meter away from the heater.
Turn off the gas valve and gas supply after its application.
Never use or store solvents and pressure pack can sans near a gas heater­even if the
heater is turned off.
Never dispose of rubbish such as cigarette butts in a gas fire­this can affect combustion
and produce dangerous pollutants.
Always operate the gas control and cylinder valve from the side or rear of the heater. Stan­
ding in front of the heater exposes you to the risk of burns.
Change LPG cylinder in ample ventilated area, and from any ignition source(candle, ciga­
rettes and so on):
Recommend to use 50mm hose for connection, which should be certified according to
applicable EN­standard;
Regulator should be certified according to EN12864(from rate:max.1.5kg/h).
BEFORE CALLING FOR TECHNICAL ASSISTANCE:
The heater can not be ignited:
●Check gas cylinder and make sure it is full.
●Check the regulator makes sure it is properly installed and it is turned on
●Check the instruction and make sure you have allowed with it correctly
If this happens after the cylinder has been changed it should be due to:
●Air in the cylinder­hold the control knob down for a longer period of time until the pilot
flame and main burner ignited. Switch to HIGH stage
●The cylinder may have been excessively cold. To reach ambient temperature before
igniting the heater is allowed.
THE HEATER TURNS OFF ITSELF:
●If the heater goes out on completing the igniting sequence, repeat the operation, fol­
lowing the instructions faithfully.
●If it goes soon after igniting, check for drafts or for the gas cylinder running out of gas.
●If is goes out after 30 minutes or so, it is signaling that it is operating in a badly ventilated
13
area.