Tabla de contenido
Publicidad
Electric Overblanket Use instructions
GENERAL SAFETY INFORMATION
Use this electric blanket only as described in this manual (laid over the bed or as a shawl,
over the user). Any other use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons.
Overblankets constitute electric heating elements that must be used with care, to avoid
impairing their operation and to prevent sores, burns or more serious consequences for
users.
Ensure that the type of mains power complies with the electrical requirements of the electric
overblanket (230V/50Hz).
Remove the electric overblanket from its packaging and check that it is in good condition before use.
Keep any plastic bags out of reach of children.
Check the cord, switch and plug before using the electric overblanket to verify that they are not
damaged.
Do not use any control other than that supplied (KDA6-FT).
This electric overblanket is not a toy. Children should be adequately supervised to ensure that they
do not play with the overblanket.
This electric overblanket is not suitable for use by persons (including children) with reduced physi-
cal, sensory or mental abilities, or without the necessary experience and knowledge, unless they
are adequately supervised and have been instructed concerning use of the electric overblanket by
a person responsible for their safety.
Do not use the overblanket on children or people who are asleep or who are insensitive to heat.
The electric overblanket must not be left unattended while turned on.
Disconnect the mains power when the overblanket is not used or for cleaning operations.
This electric blanket is designed for domestic use and may not be used in hospitals. The
electric underblanket is not designed for use in hospitals.
To disconnect the electric overblanket, slide the control switch to 0 and remove the plug from the
socket. Pull on the plug only. Do not pull on the cord when turning off the electric overblanket.
Do not carry or move the electric overblanket by gripping the cord.
Do not use the electric overblanket if the cord or plug is damaged. If the power cord is damaged,
it must be replaced by the manufacturer, dealer or a similarly qualified person so as to avoid any
safety risks.
Do not place any objects on the cord and do not bend it. During operation, the cord must be entirely
unwound.
The electric overblanket must not be operated if it is bent, crushed or wrapped around a mattress.
Do not insert metal, pointed or sharp objects in the electric overblanket and do not apply safety pins.
The overblanket must not be operated if it is bent, compressed or wrapped around a mattress.
Do not use the overblanket if it is damp or wet. Do not touch the wet overblanket - pull out the plug
immediately. Wait until the overblanket dries completely before reusing it.
Do not expose the overblanket to extreme climatic conditions (sun, rain or similar).
Do not expose the controls or electric connectors to humidity.
During operation, the controls must not be placed above or below the electric overblanket and must
not be covered in any other way. The controls should be kept outside the bed and away from the
pillow.
11
Publicidad
Tabla de contenido
