Maintenance And Cleaning; Environment Protection - Jata electro BT1022 Instrucciones De Uso

CONTINUOUS FUNCTIONING
• Once plugged to the mains push the on switch (
• Next push "Continuo". The blender starts working and the display will start the functioning time,
showing the time in seconds, and after 180 seconds, in minutes (03, 04 minutes, etc).
ATTENTION
With the "continuous functioning" it is not necessary to select another function, the blender will
always work in the maximum power independently of which pilot light is on. Don't keep working
continuously the blender in this position for more than 180 seconds (03 minutes). Leave it at least
for 1 minute to switch it on again.
• You may add ingredients to the jug while in use without opening the lid. To do so, remove the
stopper (1). Turn it anti-clockwise until the end and take it out. Add the ingredients into the jug
and place again the stopper making coincide the two flanges into the guides of the lid and turn
it clockwise until the end.
• Once you have finished, press the "Continuo" pusher to stop the blender and next press the on
pusher ( ) (6) to switch it off and wait for the blade to stop turning completely before removing
the jug.
• Take out the jug by turning until making coincide the indication (
of the body.

MAINTENANCE AND CLEANING

• Before you proceed to cleaning, make sure the appliance is unplugged from the mains.
• You may remove the blade following the next steps:
• Place the jug faced down and turn the ring clockwise. (Fig. A)
• Remove the blade set (Fig. B)
• Hold the blade with one hand and turn the transmission clockwise.
• The jug, the lid and the stopper may be cleaned with soap and water, never in the dish-washer,
taking care to rinse and dry them carefully afterwards.
• Clean the main body with a slightly damp cloth.
• Do not use abrasive or chemical products, such as metallic scourers, which may deteriorate the
surfaces of the appliance.
• Once cleaned, put the blade in the jug by reversing the steps above and making sure the washers
and joints are assembled in its original position and place the ring by turning anti-clockwise.
(Fig A)
• Be sure the ring is correctly placed when turning it and it is tightly enough. If not the jug could
loose food during the functioning.
• When storing and for your comfort you can roll the cable cord in the cord collector placed at the
bottom of the appliance.

ENVIRONMENT PROTECTION

• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the
environment.
) (6).
11
) with the indication ( )