Getting Started - Explore Scientific RDC8002 Manual De Instrucciones

GETTING STARTED

INSERT BATTERIES
1. Remove the battery door from the back.
2. Insert 2x AA (LR6)/1.5V batteries. Please ensure
the polarities (+/-) of the batteries match upon in-
stallation.
3. Reattach the battery door.
NOTE: Replace batteries when [
the display is dim.
CLOCK
CLOCK RECEPTION
1. When you insert or replace the batteries, RCC recep-
tion is initiated. To manually start RCC reception
press the [ ] button.
2. The receiving process duration 7 minutes.
3. During receiving process, the RCC signal symbol
[ ] flashes.
4. If the RCC receiving process is successful, a com-
pleted RCC symbol [
and the date and time will be set automatically. If it
fails within 10 minutes, RCC setting will quit auto-
] displays, or when
] will be shown in the display
matically. If that happens, press the [
re-initiate RCC receiving.
5. RCC receiving will automatically start at 1:03, 2:03,
3:03, 4:03, 5:03 every night. Auto receiving function
will cease if it is successful.
6. To stop RCC reception, press and hold the [
ton.
7. If the device is still not receiving the signal, please
proceed to set the time manually.
SET THE CLOCK MANUALLY
1. Press and hold [ SET ] button to enter into time and
date setting.
2. The setting parameter will flash.
3. Press [ + ] button once, the figure will increase 1 unit.
Press and hold the [ + ] button, the figures will in-
crease rapidly.
4. Press [ –/C/F ] button once, the figure will decrease 1
unit. Press and hold the [ –/C/F ] button, the figures
will decrease rapidly.
5. Press [ SET ] button to confirm setting and enter to
next parameter.
6. Sequence of setting: zone  Year (2000 – 2099)
 Date format  Month  Date  Weekday
] button to
EN
IT
DE
] but-
FR
ES
7