RP100050 Ölradiator LB5 Seite 34 Donnerstag, 22. Mai 2014 11:51 11
contact data can be found in "Service
Centre" on page 37.
4.6 Protection against injury
Warning! To avoid injury, please
observe the following information.
• Ensure that it is not possible for anyone
to trip over or to get caught up in or step
on the mainscable.
• Once hot, if you wish to transport the
appliance, switch it off, pull out the
mains plug, and wait until the appliance
has cooled down. Otherwise you could
burn yourself on the hot surface.
5.1 Setting up the appliance
Note: Because the supplied appliance and
its heating coils are coated with a thin film of
grease, you may notice a small amount of
smoke and odour the first time it is used. This
is not harmful and will stop after a short
while. Ensure adequate ventilation during
this time.
1. Take the appliance out of its packaging.
2. Remove the transport packaging.
3. Check that the appliance has not
sustained any damage.
4. From underneath, slide the rear foot 6
completely
onto
element 3.
5. From the front, slide the front foot 7 onto
the corresponding receptacle and push
it in until it latches into place.
34
4.7 For the safety of your child
• Ensure that the packing foil does not
4.8 Protecting the environment
• In the event that the appliance develops
5. Unpacking and setting up
6. Check that the
7. Select a location in line with the safety
8. Check that the control knob 4 is set to
the
last
heating
9. Insert the mains plug into a power
Warning! Children often cannot
assess dangers correctly and are
injured as a result. Please therefore
observe the following:
become a deadly trap for a child.
Packing foils are not toys.
a leak and loses oil, it may on no
account be used again. Collect the
leaked oil and dispose of it together with
the appliance as directed in section
"8. Disposal" on page 36.
appliance
steadily.
Warning!
– Ensure that it is located suffi-
ciently far from walls, fixtures
and other appliances. The dis-
tance must be at least 0.5 m to
exclude the risk of fire.
– The appliance may be operated
only when upright.
instructions (see "4. Safety information"
on page 31).
"OFF".
supply socket that meets the technical
data requirements (see "3. Technical
data" on page 31).
stands