Gallagher B80 Manual De Instrucciones página 9

Gallagher 3E0917 B80 B180 B280 Portable Fence Energizer
Step 2
Connect to earth (ground) system
Using Lead-out Cable G6270 remove 5cm (2") of plas c coa ng from one end of
the cable and a ach to the green terminal on the Energizer. A ach the cable to the
earth system by removing 10cm (4") of insula on from the cable at each Earth Stake,
then clamp the exposed wire to each stake using an Earth Clamp G8760. Tighten the
clamp.
For portable fencing – earth lead is provided.
Step 3
Connect the fence
Connect Energizer's red terminal to the fence
using Lead-out Cable G6270: remove 5cm
(2") of plas c coa ng from one end of the
cable and a ach to the red terminal on the
Energizer. A ach the other end of the cable to
the fence using a Joint Clamp G6030.
For portable fencing – fence lead is provided.
Step 4
Connect the ba ery
Connect the ba ery leads from the
Energizer to the ba ery: red lead to
the (+) terminal of ba ery, black lead
to the (-) terminal of ba ery. Use
external 12V deep cycle lead acid
rechargeable ba ery. Do not use non-rechargeable ba eries. During charging, place
lead acid ba eries in a well-ven lated area.
Connect to Mains Power Adaptor
Green
To earth
(op onal accessory G40100)
Red
To fence
To ba ery
A ach cable
as shown
9