INFOSEC UPS SYSTEM E3 Live RM 500 VA Guía De Usuario página 23

The on/off Button is
designed to prevent
damage by rapidly turning
it off and on.
The UPS will The unit is not connected
to an AC outlet.
not turn on
The battery is worn out.
Mechanical problem.
Circuit breaker is tripped
due to overload
Outlets do not
provide power
Batteries are discharged
to equipment
Unit has been damaged by
a surge or spike.
Alarm
Alarm code Battery
A06 capacityis low
Alarm code
EPO active
A16
Fault
Fault code
INV soft start fail
F06
Fault code
INV volt high
F07
Fault code
INV Volt low
F08
Fault code
Output circuit short.
F09
Fault code
Battery voltage is too high.
F11
Fault code
Battery voltage is too low
F12
Fault code
Battery is overcharge
F13
Fault code
Over load occurs.
F14
Fault code
load unbalance
F15
Fault code
Fan has been damaged.
F18
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 07 19 AA 36 205 09
Turn the UPS off. Wait 10 seconds and then turn the
UPS on.
The unit must be connected to a 220-240V 50/60Hz
outlet.
Contact Technical Support.
Turn the UPS off and unplug at least one piece
connected equipment. Unplug the power cord of the
UPS then press the circuit breaker knob.
Allow the unit to recharge for at least 4 hours.
Contact Technical Support.
Alarm code Battery
A09 disconnected
Alarm code Over
A18 temperature
Restart the UPS, if the fault is still, contact Technical
Support
Your attached equipment may have problems, please
remove them and check again.
1. Shut down the UPS
2. Check the counts of Battery
3. Check battery connector when use battery
packages.
Shut off non-essential equipment. If this solves the
overload problem, the UPS will transfer to normal
operation.
Shut down the UPS, Replace the fan
Alarm code
Over load occurs.
A14
23