Audible Alarms - INFOSEC UPS SYSTEM E3 Live RM 500 VA Guía De Usuario

Note : 1 segment = 25%
Input indications :
Line
mode
Batt.
Mode

3.3 Audible alarms

Alarm
Off
Beep 1 time In Every 30 Seconds
Beep 1 time In Every 2 Seconds
Beep 1 time In Every 0.5 Second
4. TROUBLESHOOTING
Refer to the table below when the UPS is not working properly.
Problem Possible Causes
Abnormal
1. AC Input missing
Mains normal
but not Works
2. Input Breaker is tripped
in AC mode
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
22
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 07 19 AA 36 205 09
Alarm/Fault
Bat mode: battery
capacity
Line mode:
1. Battery charging:
flashning
2. Battery full
charged: lighting
Initial
Utility Failure – The UPS is providing battery power to outlets.
Utility Failure – The UPS is providing battery power.
The rapid beeps indicate the battery will run out of power shortly.
Overload - Occurs when connected equipment exceeds the rating of the unit.
Turn the UPS off and unplug at least one piece of equipment from the UPS.
1. Check AC input connection.
2. Unplug the power cord of the UPS, then press the
circuit breaker knob.
2th
Condition
Normal
Remedy
Sound disable
(Press the mute key
3s to disable and
enable the buzzer
sound)
Load capacity
3th