Accessmatic accesloop500 Manual De Usuario página 17

accesloop
500 5242
Opening your life
Operating status indicator
The vehicle detector will start self-calibration after turning on the power supply. In the course of self-calibration, "POWER"light keeps
normally ON， "DETECT"light indicates working sensitivity degree with ashing times。 "H"gear ashes 3 times， "M"gear ashes 2times，
"L"gear ashes 1 time。 After self-calibration ， "DETECT"light is auto-o ， the system is at waiting state。 When there is vehicle traveling on
the coils ， "DETECT"light will light on while "DETECT"light will ash on if the coil is not detected in the calibration process.
Sensitivity adjustment and reset
Detection sensitivity has three degrees:(High、 Middle 、 low) and can be set by the toggle switch as showed in Figure 2。
Figure 2.
"H": HIGH
"M": MEDIUM
"L": LOW
Fig. 2 Fig. 3
Front panel Reset Function
The reset function can be realized by inter-conversion between any two gears as Figure 3
Function Set
1. Operating Mode Conversion
Vehicle detector includes presence output and pulse output, the internal dip switch can achieve the conversion 。
SW1 is "ON" ,status signal output from Relay1， No output from Relay2 ；
SW1 is "OFF", （SW1 lie at the end with numbers） ， status signal output from Relay1, pulse signal output from Relay2 （ pulse width: 200ms).
www.accessmatic.com
2